Do you know how to connect grooved pipe fittings?

Do you know how to connect grooved pipe fittings?

Do you know how to connect grooved pipe fittings?
1. Clamp installation
(1) Install the sealing ring: Put the sealing ring into one end of the pipe opening, then align the other pipe opening with the pipe opening, move the sealing ring to the sealing surface of the two pipe openings, and the two sides of the sealing ring should not extend into the grooves of the two pipes.
(2)   Cap, make sure that both ends of the shell enter the groove until tightened.
2. Mechanical tee and mechanical cross installation
First remove a bolt from the shell, loosen the other nut until the bolt end is stepped, rotate the lower shell about 90 degrees away from the upper shell, place the outlet part of the upper shell at the opening of the pipe opening and align it with the hole, and then rotate the lower shell along the pipe end (if it is a mechanical cross, the lower shell method is the same as the upper shell) to close the upper and lower pieces.
3. Flange installation
Install the flange: first loosen the screws on both sides, separate the two flanges, respectively install the ring key parts of the two flanges into the grooves of the slotted pipe ends, then insert and tighten the screws on both sides to adjust the gaps on both sides to be close.
Install the sealing ring: Place the "C" shaped opening of the sealing ring facing away from the flange and push it into the inner diameter groove of the flange along the direction of the pipe end.